1. 中央空调内置型臭氧发生器

 

1 central air conditioning with built-in ozone generator

 

将臭氧发生器安置在中央空调送风道或回风道内部，利用空调的风力将臭氧发生器产生的臭氧输送到需要消毒的车间内。这种臭氧发生器使用简单，臭氧气体也能方便地投送到需要消毒的车间内。

 

The ozone generator is placed in the central air conditioning send duct or return within the Tao, the use of air conditioning wind will be generated ozone generator ozone transported to the need for disinfection of the workshop. The ozone generator is simple to use, the ozone gas can be easily delivered to the need for disinfection of the workshop.

 

但由于是安置在空调风道内，所以发生故障时，不易察觉，维修也不方便；另外如果空调风不洁净的话，对臭氧放电体等配件的损害是很严重的。所以这种方式已经逐步被淘汰。

 

But because it is placed in the air conditioning duct, so when the failure is not easy to detect, maintenance is not convenient; in addition, if the air conditioning air is not clean, the damage to the ozone discharge body and other accessories is very serious. So this way has gradually been phased out.

 

2. 中央空调外置型臭氧发生器

 

2 central air conditioning external type ozone generator

 

将臭氧发生器的臭氧出口通过管路送入中央空调送风道内，和内置型臭氧发生器相比，这种方式不仅仅是方便安装和维护，而且臭氧发生器不受空调风的影响。

 

The ozone generator ozone is sent through the pipeline into the central air-conditioning duct, and the built-in ozone generator, this way is not only convenient for the installation and maintenance, and the ozone generator is not affected by air conditioning.

 

如果没有中央空调，可以在车间较高处铺设管道，在管道上开孔，也可以很好的将臭氧输送到整个空间。这种方式有几个好处：一是能够远距离输送臭氧，并且使臭氧均匀散布；二是一台臭氧发生器可以对多个车间进行消毒，或只针对特定的车间消毒；三是可以将臭氧发生器安放在被消毒车间外，避免车间潮湿对臭氧发生器的损坏。

 

If there is no central air conditioning, can be higher in the workshop to lay pipes, open hole in the pipeline, but also very good to transport the whole space. This approach has several advantages: first, to transport ozone, and so that the ozone evenly distributed; two is a ozone generator can be used to disinfect a number of workshops, or only for a specific workshop disinfection; three can be placed in the ozone generator is disinfected, to avoid the workshop humidity damage to the ozone generator.

 

3. 壁挂式臭氧消毒机

 

3 LHK

 

将臭氧消毒机悬挂在车间内墙壁的高处，通过臭氧消毒机内置的风机将臭氧气体吹送到车间内。这种臭氧消毒机由于结构、风力等方面的限制，只适用于小空间的灭菌除味，当车间面积较大时，需要安装多台才能达到消毒效果。

 

The ozone disinfection machine is suspended in the high place of the wall of the workshop, and the air blower of the ozone disinfection machine will blow the ozone gas into the workshop. This ozone disinfection machine due to the structure, wind and other aspects of the limit, only for small space of sterilization in addition to taste, when the workshop area is larger, need to install more than one can achieve disinfection effect.

 

4. 便携式臭氧发生器

 

4 portable ozone generator

 

上部带有提手的臭氧消毒机,可随意移动到需要消毒的空间内使用。由于臭氧比空气重，对空间消毒时，最好将臭氧发生器放在较高的位置使用。这种臭氧发生器和壁挂式类似，只是移动性强一些，适合小空间内使用。

 

The upper part of the ozone disinfection machine with handle, can be moved to the space in need of disinfection. Because ozone is heavier than air, it is best to use ozone generator in high position when space is disinfected. The ozone generator and a wall mounted similar, only strong mobility, suitable for use in small space.

 

五、臭氧投加量的计算

 

Five, the calculation of ozone dosage

 

臭氧投加量需要根据车间容积大小、消毒时间来确定。比如说，一个普通的1000立方米的车间消毒一小时（不包括30分钟的臭氧后续消毒时间），那么按照不低于10mg/m³臭氧浓度的要求，这1000立方米的车间在一小时内需要投入10000mg臭氧（即10g）。如果是铺设管道的方式则需要加大20%-30%的臭氧投加量。

 

The amount of ozone dosage should be determined according to the size of the shop floor and the disinfection time. For example, an ordinary 1000 cubic meters of workshop disinfection for an hour (not including 30 minutes of ozone follow-up disinfection time), then in accordance with the requirements of not less than 10mg/m³ ozone concentrations, the 1000 cubic meters of workshop in an hour need to be put into 10000mg ozone (ie 10g). If it is the way of laying pipelines need to increase the amount of ozone 20%-30%.